Wheel Stud - 2'076 items found

How to replace a wheel stud bolt

How to replace a wheel stud bolt

GENEVA MOTOR SHOW: Is Ferrari's LATEST V12 GT A STUD or a DUD? YOU Decide... - AutoSpies.com

The F12 Berlinetta looks fast and very aerodynamic design but the design lacks elegance and flowing lines. Very function over form design. I like good balance of function and form in designs especially in Super Cars like Ferrari. One example is Nissan GT-R, Most people say the performance and price is fantastic but the design makes them stay away and.

Source: www.autospies.com

Yahoo answersHow do I replace a wheel stud / lug nut on my 2003 Sentra? How dangerous is it to be driving my car now?

  • When it was being replaced, one of the wheel studs and lug nuts broke. I have bought a new wheel stud and lug nuts. Is replacing these parts something I can do at home. If so, how. And how dangerous is it.

    08/27/07
  • Maintenance & Repairs

    Not only is it dangerous, but it's a huge legal liability. Without even torque, you can get excessive twisting on the remaining studs. If they break and you're invovled in an accident, they could.

Yahoo answersHow to replace a wheel stud in a toyota camry?

  • Rex

    I have 1994 toyota camry LE and the right front wheel stud is worn out and a second one is missing. I need to replace them. Could someone who knows how to do this give me a good advise. I have already taken off the wheel and put a side a rotor.

    10/25/10
  • Maintenance & Repairs

    Look behind the studs on the hub. There is usually one little spot where the stud can back all the way out, like a pocket cut into the metal. anywhere else the stud will bump into the yoke or some.

Yahoo answersHow do I replace a front wheel stud on a 2002 Diamante?

  • AldoAnswers

    The manual says to drive it out from the hub, but the stud shoulder hits the wheel bearing housing. There isn't enough clearance to get the broken stud out, much less the new one in. I need to hear from someone that has actually done this repair.

    09/11/08
  • Maintenance & Repairs

    Having not done stud replacement on a Diamante I can only say to look for a position where the base of the stud can clear the knuckle assembly. if no spot exists where it will clear then you must.

Yahoo answersHow do you change a rear wheel stud on a 2008 Jeep Wrangler?

  • Train4MMA

    TireWarehouse cross threaded a lug nut and ruined a wheel stud. It's the rear driver side, how do I change it out. Are there any special tools needed.

    12/09/10
  • Jeep

    There's always the question - do you take it back to somebody who screwed it up already. If it's something big, I'd probably take it back - and stand over them and watch to make sure it got fixed.

Yahoo answersHow Do I Replace a Wheel Stud on a Vehicle with ABS?

  • Heero Yui

    Vehicle has a contraption that keeps me from getting to the rear of stud. I have removed caliper completely, rotor is off as well. I have even gone so far as to remove the hub from the axel, and I still cannot see where I can insert the wheel.

    11/05/07
  • Maintenance & Repairs

    Take center nut for the axel off. Then there should be a 3 or 4 bolt bearing pack, that's what the studs are attatched to. Then you can find where to insert the wheel stud. First make sure all.

Yahoo answers1993 buick century trying to remove broken wheel stud?

  • I have been trying to remove a broken wheel stud in the rear where I have drum brakes. They are pressed in and says not to hit with a hammer. I tried 2 use a c clamp but doesnt work all that well where can i get the tool to remove these studs.

    08/09/09
  • Maintenance & Repairs

    The way i remove them is with a hammer. (wear goggles). To press the new one on is to buy an extra lug nut and. put some washers between stud and lug nut. Tighten lug nut and the stud will pull into.

Breaking News

  • AutoSpies.com
    GENEVA MOTOR SHOW: Is Ferrari's LATEST V12 GT A STUD or a DUD? YOU Decide...

    the older 550/575M in the rear window -- look at the way the window line kinks up slightly and those large diameter five-spoke wheels. Philosophy aside though, at the end of the day only one thing matters: Is this all-new Ferrari a STUD or a DUD?

  • AutoSpies.com
    STUD OR DUD? Is KIA Ready To Carve Out A Niche In BMW's Turf With The K9 Flagship?

    Soon-Nam Lee, Kia's Director of the Overseas Marketing Group, commented on presentation of the firm's new flagship : "K9 is our first rear-wheel drive large sedan, created without compromise in its design, driving performance and new technologies.

  • Tyrepress.com
    Performance Wheels releases Fondmetal 7900

    The sole UK distributor of Fondmetal wheels has announced details of the latest design from the Italian manufacturer: the 7900. Performance Wheels says the five-spoke rim contains construction and material technology developed by Fondmetal in its

Leave a Comment

Fields with * are required.