Automobile magazine C.V. Boot Kit


Easy boot for cv-joints. Easy to install on the car assembly in 15 minutes.

CV-Boot easy to install on the car assembly in less then 15 minutes. Easy Boot cv-joint is an inve.

  • SPHINX

    whats the name of the rubber coil that contains the grease that lubricates the wheel of a car?

    this coil in my car is ripped and all the grease in leaking out. I need to find the name of it so i can buy one and replace it.


    C V BOOT (it holds grease around the Constant Velocity joint's ) there are 2 on each shaft one at the [wheel or yolk end C V Joint ] and one at the end just before entering the transmission . The.

  • Robert

    What would be a fair price for a shop or dealer to replace a C/V sealing boot on a 2001 Jeep Grand Cherokee?

    Driver side, the boot has a tear about one inch or inch and a half, no other problems.


    Usually the shop replaces the complete drive axle especially on an older vehicle like yours even if it's just a torn CV boot. The new remanufactured drive axles are good and yet inexpensive.

  • rosendo

    How do you rebuild the CV Boot of a front axle on a 1999 Nissan Quest?

    My 1999 Nissan Quest has a busted C. V boot and I wanted to know how to rebuild it, instead to having to go to a shop.


    The correct size quest axle boot kits are only available from Nissan for the do it your selfer that is the boots straps and kits to get Now your going to need to know that the quest is different.

  • and1_player547

    Is there a Seal on my C/V Joint on my 2001 S10 ?

    I recently just replaced my passenger C/V joint on my 2001 4WD ZR2 S10 Pickup. The old on had a craked boot. Well i recently just put it all back together and now three weeks have goine by and i am noticing that a leak is coming straight out of.


    Here is the repair procedure from www. S10 Pickup, Sonoma 2000-2004. CV-Joints. Inner CV-Joint & Boot. This procedure requires the use of the following: J 35566.

  • Mart B

    Is it worth replacing cv torn boot with cv boot kit?

    is it worth saving the extra bucks by just replacing the torn booth with a booth kit or go with paying a bit mroe and replacing the whole cv joint.


    Replace the whole axle. Axles have gone way down in price over the past 10 years. The labor to replace it will be the same if you were to replace just the boot. Also if the boot has been torn for.

  • Big Al

    Lifted truck pros and cons?

    I am looking to buy a 2003 dodge ram 1500 with a 3 inch lift on it and 36 inch tire. I was just wondering the pros and cons of it ( I already know gas is a con), and what are some things to look for that normally have higher wear with big tires.


    seriously,. bigger tires. if you drive it like an old lady on the street, you will get better mileage. save hills. boots/ joints" all that will be fine.

Books

  • Automotive Chassis

    Cengage Learning. 2014. ISBN: 1401856306,9781401856304. 551 pages.

    This user-friendly resource will thoroughly prepare readers to work in the important area of automotive technology known as chassis systems. It features accurate and up-to-date coverage of both brakes and suspension/steering in one complete volume. Technically precise drawings and photographs are prominently featured, supplying the visual support necessary for readers to grasp important principles and practices. The first half of the book is devoted to the latest information on brakes, including friction materials, drums, and rotors. The newest tire information is presented, followed by current suspension, steering, and wheel alignment material. The balance of the book is dedicated to front and rear wheel drive shafts and axles, and vibration analysis. Diagnosis and troubleshooting of worn and failed parts is emphasized throughout.

  • Automotive Service: Inspection, Maintenance, Repair

    Cengage Learning. 2011. ISBN: 9781111128616,1111128618. 1552 pages.

    The newly-revised 4th edition of AUTOMOTIVE SERVICE: INSPECTION, MAINTENANCE, REPAIR contains all the knowledge and skills necessary for a student to be successful in a number of automotive careers. This text covers all eight major course areas of automotive technology by progressing students through an introduction to shop management and then covering theories of vehicle systems operations with step-by-step procedures for trouble-shooting and repairing automobiles. Technically reviewed by instructors and industry experts, the 4th edition of this popular text is designed in particular for students enrolled in NATEF-certified programs. Updated and expanded content in this edition includes coverage of hybrid vehicles, HTHS viscosity ratings, latest coolants, ejector cycle systems, dynamometer, and turbochargers and superchargers. Important Notice: Media content referenced within the product description or the product text may not be available in the ebook version.

Leave a Comment

Fields with * are required.